J-Tape

Home > Restore Devices > J-Tape

J-TAPE
By "Johnny" and provided from: Clark <rivrbend@tomatoweb.com>
and John Hyde jhyde@pop.long-beach.va.gov

Source: http://www.eskimo.com/~gburlin/restore/archivefaq2.htm

Step 1: I strongly suggest the 3M Micropore Tape, since it sticks very well, and it's VERY easy to remove when taking a shower without tearing your skin apart! Rolls are available alone, but I suggest you get the useful dispenser that 3M sells. This dispenser makes cutting pieces of tape a piece of cake! You will need the one inch (1") wide tape. Cut 5 pieces, 2.5" long, and one long piece--its length equal the circumference of your dick shaft (soft) + 1 inch.
Step 2: Using your fingers, pull on the skin over the glans as far as possible. Without hurting yourself! Roll the skin back and forth between your fingers until you feel that the tension on both the outside and inside are equal.
Step 3: Then, using a pen, make a mark on the edge of the fold. This mark indicates your "Equilibrium Point" or "POE".
Step 4: Roll the long piece of tape around your shaft, sticky side OUT. The bottom side of the tape MUST BE one half inch (1/2") higher (towards the glans) than the mark you just did ('cause the tape is one inch [1"] wide. I recommend being a LITTLE hard; it helps applying the tape correctly.
Step 5: Roll the skin. Holding your glans steady with your fingers, roll the skin onto the tape until your equilibrium point reaches the middle of the tape. Then gently apply pressure with your left hand (if right handed) all around the shaft to ensure good contacts between the tape and the skin.
Step 6: Apply pressure. Just to be on the safe side, you can gently "squeeze" the tape and the skin together with your fingers (I don't do this anymore, but when you start, it can help).
Step 7: Add the small tapes. Now apply one small tape onto the tape around your dick by putting 1" of the sticky side of the small tape onto the sticky side of the tape around your dick. You now have a 1.5" piece of tape extending up beyond the tape around your dick. You'll get better results if half an inch of the tape is on the skin (no more, no less). Here, both sticky sides of the tapes should be in contact with each other. Then, fold the loose part of the tape, the part sticking up, in two. This will be one of the "ears" of the tape which you will clip to your elastic strap. Do the same with the other small tapes until you fill all the "free spaces" around your shaft.
Step 8: "The Flower." The end result should sort of look like a flower. Neat, hey?!
Step 9: As you can see, the end result looks a lot like the original T-Tape method, but it will take you between 3 and 5 minutes to get the same result. You won't need to be hard to install the tapes, and there are no more tapes to prepare!!! Quite faster, ain't it?!
Step 10: Now, wrap all the tapes together, so it becomes easy to grab all of them, and clip them together with your elastic strap and voila!