Step One
|
This is you P.U.D. This is the GP model, there is another model that is the standard tugger,
but i went with the more anatomical looking device.
|
Step Two
|
Another cool feature of these devices is that you do not need to untape to urinate. There is a threaded
hole that is good for urination and also this device come with an ad-on piece that allows you to use more weight if needed.
|
Step Three
|
Here is the tape I recomend that you use. It is made by 3M and it is 2 inch micropore paper tape. This
tape holds very well and also when you want to take it off, you can just get it wet and it will peel
off with out any problems, ie skin tears.
|
Step Four
|
When you go to apply the P.U.D. to need to make sure that your urethra is lined up with the
opening of the P.U.D., if it is not it will make a mess when trying to urinate.
|
Step Five
|
As you start to pull the skin up over the device, you need to pull the inner skin up as far as
you can, if you don't, it will cause uneven tension from the outer skin and the inner skin, this
will hamper your results.
|
Step Six
|
Ok, now if you pulled the skin up all the way as you can, the skin will hold on to the outer surface of
the P.U.D., it will look like this.
|
Step Seven
|
Go Ahead and prime your tape, pull off about 1/2 of an inch.
|
Step Eight
|
Start taping your skin to the P.U.D., you will need to use your fingers to hold the skin up on it
as you apply the tape around the device.
|
Step Nine
|
When you are taping you will want to make 2 passes around the P.U.D., this will make the
paper tape strong enoough. Also durin the first pass and on to the second pass, use one of your
fingers to push the tape on to both your skin and the P.U.D., BUT MAKE SURE YOU DO NOT TAPE TO
TIGHTLY as it might start to cut off circulation to your skin.
|
Step Ten
|
Once you have the second pass about done, take a pair of scissors and CAREFULLY cut the tape
so that it will bairly over lap the bottom layer.
|
Step Eleven
|
Ok, once you have done that, this is what it should look like.
|
Step Twelve
|
Great you are done!.
|
Optional
|
This is optional, I built this to use my P.U.D. during the night, having the device just hanging there
during the night can be painfull, so I went down to my local Wallmart and picked up 1 inch wide elastic
strap, you will need about 2 feet. Also you will need to pick up some sort of knee strap like I have. When
you buy or bought your P.U.D. it came with a eyelet ring that is threaded on one end so that it will thread
into the P.U.D., take this and run the elastic strap through it and double it up on its self, and then sew
this together or have your misses, next fit the pud on you and also the knee strap. Once you have done this
measure out the elastic strap down around the knee strap, you want a good amount of tension but not enough
to cause pain. Once you have done this, fold it over on it self and sew that end together, leave about 2 inch
opening or what ever you think will be neede for it to funtion properly. There you go, instant night harness!!
|
